Cleaning; Faults And Remedial Measures; Disposal - Jamestown Landon Bedienungsanleitung

GB
WARNING! Danger of fire! If the lid is left
open, the feeding rate would increase and the
temperature would overshoot.
Temperature Probes
– This pellet grill has two built-in temperature probes
to measure the temperature of the food as it is being
cooked.
– Insert the probe into the food. Plug the connector
into the receptacle of the control panel. The temper-
ature of the food would be shown on the LCD.
Turn off the grill
To safely turn off the grill, please follow the steps below:
– Open the upper cover of the control box, remove the
residual fuels from the box and keep it properly for
the next use.
– Let the grill continue to work for 5 to 10 minutes to
discharge the fuel in the feeder.
– Click the On/Off switch to turn off the grill, but do not
unplug the power right now. At this time, the cooling
fan would continue to work for 5 minutes until all the
fuels are burned off and extinguished.
– Finally, unplug the power, and store the grill in a cool
and ventilated place to avoid sun exposure and
heavy rain.

Cleaning

WARNING! Danger of being burnt! Let the
grill cool down completely before cleaning.
Fault/malfunction
Ignition fails
[Err] shows on the LCD
Low-temperature protection
High-temperature protection
Note: After failure, the control panel must be
reenergized and reset.
If you can't fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs will
also invalidate the warranty and additional costs may be
incurred.

Disposal

Disposal of the appliance
A crossed-out wheelie bin icon means: Batter-
ies and rechargeable batteries, electrical or
electronic devices must not be disposed of with
household waste. They may contain sub-
stances that are harmful to the environment
and human health.
32
• Cleaning is required after each use. Clean grates
• Clean grease pan, grease trough, and grease drain

Faults and remedial measures

When something isn't working...
Malfunctions are often caused by minor faults. You can
easily remedy most of these yourself. Please consult
the following table before contacting the vendor. You will
save yourself a lot of trouble and possibly money too.
Cause
There is fuel in the fire cup but it is not
ignited
No fuel in the fire cup because the pel-
let fuels are too large to enter the
feeder
The feeder screw stops
The ignition rod of the igniter does not
work
Failure of the sensor in the grill
When the temperature is less than
57 °C for 6 min, the grill would be
powered off and the display would
show [ERL]
When the temperature is higher than
323 °C, the grill would be powered off
and the display would show [ERH].
The fan would keep running for 10 min
until temperature decreases to 54 °C.
Consumers must dispose of waste electrical devices,
spent portable batteries and rechargeable batteries
separately from household waste at an official collection
point to ensure that these items are processed correctly.
The product can be returned free of charge in accord-
ance with the legal requirements, for example through a
municipal waste disposal company or a dealer.
Batteries, rechargeable batteries and lamps
that are not permanently installed in waste elec-
trical equipment and can be removed in a non-
destructive way must be removed and dis-
posed of separately before disposal of the equipment.
Lithium batteries and rechargeable battery packs of all
systems are only to be handed in to the waste collection
points in a discharged state. The batteries must always
be protected against short circuits by taping off the
poles.
NOTICE! Risk of damage to the device! Do
not use any sharp or abrasive objects, or
aggressive cleaning agents.
Do not use cleaning solutions.
using a wire grill brush. Do not use oven cleaners or
abrasive cleaners to clean any painted grill sur-
faces. Use warm soapy water to clean painted sur-
faces.
tube occasionally. A spatula could be used to scrape
excess grease and a grill brush to brush clean.
Avoid grease buildup on the grease tray or in the
grease trough as this could cause flare-ups inside
the grill. Make sure not to obstruct the flow of grease
off of the tray and into the grease rough. Make sure
not to block the airflow to the temperature sensor on
the left side of the grill.
DANGER! Risk of injury! Improperly per-
formed repairs can lead to the device not func-
tioning safely. This endangers yourself and
your environment.
Remedial measure
Turn the dial off and on and try to ig-
nite again
Use smaller pellet fuels
Check cables, plug, socket and fuse.
Check cables, plug, socket and fuse.
Check or change the sensor in the grill
Shut off the display, unplug the power
and plug the power again, then restart
it.