Set The Dial Mode; Set The Flash Time; Change The System Pin Code; Registration - Geemarc AMPLIDECT 295 Photo Bedienungsanleitung

9.4.4

Set the Dial Mode

The default dial mode is best suitable for your country and network operator. It is
unlikely that you should need to change this setting unless advised to do so.
1. Press LEFT SOFTKEY and
SOFTKEY and / to select DIAL MODE.
2. Press LEFT SOFTKEY and /
PULSE).
3. Press LEFT SOFTKEY to confirm
9.4.5

Set the Flash Time

The default flash time is best suitable for your country and network operator. It is
unlikely that you should need to change this setting unless advised to do so.
1. Press LEFT SOFTKEY and
2. Press LEFT SOFTKEY and
3. Press LEFT SOFTKEY and
100ms, MEDIUM 300ms, LONG 600ms)
4. Press LEFT SOFTKEY to confirm.
9.4.6

Change the System PIN Code

1. A 4-digit system PIN code is used for changing the system settings of the base
station. It is used to protect your phone against unauthorized use. The default
system PIN is 0000. Press LEFT SOFTKEY
SETTINGS.
2. Press LEFT SOFTKEY and
Press LEFT SOFTKEY and you are requested to enter the 4-digit system
PIN.
3. Enter the old system PIN.
4. Press LEFT SOFTKEY and enter the new system PIN.
5. Press LEFT SOFTKEY and enter the new system PIN again.
NOTE:
If the new PIN entered in Step 6 is not matched with the new system PIN
entered in Step 5, user is requested to enter the valid system PIN again in Step
5.
6. Press LEFT SOFTKEY to confirm the setting.
/ to select BS SETTINGS. Press LEFT
²
²
to select your desired dial mode (TONE or
/ to select BS SETTINGS.
/ to select FLASH TIME.
/ to select your desired flash time (SHORT
.
and / to select BS
/ to select CHANGE PIN.
32

9.5. Registration

Your handset and base station is pre-registered. Up to four handsets can be
registered to a single base station.
If for some reason, the handset is not registered to the base station (
when the handset is near the base station), register your handset according to the
following procedure.
1. SOFTKEY and / to select REGISTRATION.
2. If you have more than one base, press LEFT SOFTKEY
the base number from BASE 1, BASE 2, BASE 3 and BASE 4. There will be a
behind the current registered base number.
to display "PIN?" enter the 4-digit system PIN for
3. Press LEFT SOFTKEY
the base (default PIN is 0000).
and the display will show "WAITING".
4. Press LEFT SOFTKEY
5. At the same time, press and hold
the registration mode.
After a short delay, if the registration is successful, there will be a confirmation beep,
and the handset display will go back to idle mode with the new handset number
shown. The base display will also go back to idle mode.
flashes even
and / to select
/HANDSET LOCATOR on the base to enter
33