Remote Operations; Troubleshooting - Geemarc AMPLIDECT 295 Photo Bedienungsanleitung

10.5.10.3

Remote Operations

If you are away from your home, you can call your answering machine to switch on
or off the answering machine and listen to your messages remotely using another
tone-dialing phone.
1. Place a call from a tone-dialing phone.
2. When the answering machine answers the call and starts playing OGM, press .
3. Enter the 4-digit Remote Access PIN (default PIN is 0000).
4. Press the following keys to carry out your desired function.
Keys
While message is not playing
2
4
5 Play the message
6
7
Turn on the answering machine
9 Turn off the answering machine
* Enter the 4-digit remote access PIN
NOTE:
•
When your answering machine memory is full and the answer mode is in
ANS & RECORD, the answer mode will change to ANSWER ONLY automatically.
It will change to ANS & RECORD mode automatically after some messages have
been deleted.
Functions
While message is playing
Delete the current message
playback
Repeat playing the current
message from the beginning.
Press twice to skip backward to the
previous message.
Pause the current message playback
Press again this key to continue the
playback.
Skip forward to play the next
message
42
11.

TROUBLESHOOTING

If you have difficulty with your phone, please try the suggestions listed below.
Problem Solutions
•
My telephone does Make sure the battery is installed and charged correctly.
not work at all.
•
For optimum daily performance, return the handset to
the telephone base after use.
•
Make sure the power adapter is securely plugged into an
outlet not controlled by a wall switch.
•
Make sure the telephone line cord is plugged firmly into
the telephone base and the telephone wall jack.
•
Unplug the electrical power to the telephone base. Wait
for approximately 15 seconds, then plug it back in. Allow
up to one minute for the handset and telephone base to
synchronize.
•
Remove and re-insert the battery. If that still does not
work, it might be necessary to purchase a new battery.
•
Disconnect the telephone base from the telephone
wall jack and plug in a working telephone. If the other
telephone does not work, the problem is probably in
the wiring or the telephone service. Call your telephone
service provider.
•
Low battery shows Place the handset in the telephone base for recharging.
on screen.
•
Remove and re-install the battery and use it until
fully depleted, then recharge the handset in the
telephone base.
•
If the above measures do not solve the problem, replace
the battery.
•
The battery do Make sure the handset is placed in the telephone
not charge in the base correctly.
handset or the
•
Remove and reinstall the battery, then charge for up to
handset battery do
16 hours.
not accept charge.
•
Purchase a new battery.
43