Setting up
1 - Connecting the telephone
- Connect the handset cord.
- Open the battery compartment.
- Insert 4 alkaline batteries (type AAA 1.5V, not
supplied) in the compartment (*). Batteries are
required if you wish to increase the ringer level up
to 10 dB.
- Snap the battery door back in place.
- Connect the line cord plug into the line socket on
the rear of the unit (*).
- Connect the other end of the line cord into the
wall PTT socket (*).
2 - Ringer volume setting
A switch located on the right side allows the ringer
to be switched to Hi,Low or Off:
: Off,
: Low,
: Hi
Note: The ring level will be increased of 10 dB if
you insert batteries.
7