Setting Up; Connecting The Telephone; Ringer Settings - Geemarc CL1100 Bedienungsanleitungen

1 - CONNECTING THE TELEPHONE

1. Connect the handset cord.
2. Open the battery compartment by pulling back the latch.
3. Insert correctly 4 x AAA 1.5V alkaline batteries (not supplied) in
the battery compartment (*). Batteries are required if you wish
to increase the ringer level up to 10 dB.
4. Snap the battery door back in place.
5. Connect the line cord to the socket (*).
(*) Classified TNV-3 according to EN60950 standard.

2 - RINGER SETTINGS

A switch located on the upper side allows the ringer to be switched
HI, LOW, OFF :
: Off,
Your phone comes with the ringer switched to «High» and the
melody set to «6»:
Melody 1
Melody 2
Melody 3
If you don't like the ringer melody, you can choose a new one by
changing the settings as per instructions below:
- Lift the handset.
- Press
- Press # button.
- Press any of the 1 - 9 dial keys.
The new ringer settings will be activated with the next incoming call.
Note: The ringer level will be increased up to 10 dB if you insert
batteries into the battery compartment.

SETTING UP

SETTING UP
: Low,
Low
1
4
7
button.
: Hi
Mid High
2 3
5 6 (by default)
8 9
5