Geberit ESG 3 Betriebsanleitung Seite 49

Malfunction
<Malfunction>
and
<Welding complete>
LED displays
light up.
<Malfunction>
and
<Ready for welding>
LED displays
up.
<Malfunction>
<Welding procedure>
and
<Ready for welding>
LED displays
up.
9962820747 © 01-2023
966.473.00.0(03)
Cause
Electrofusion
machine is
overheating or
operating at too
high an ambient
temperature.
Operating at too
low an ambient
temperature.
light
,
Fault current
while welding,
e.g. as a result
of moisture on
electrical
light
connections.
Rectification
▶ Let electrofusion
machine cool down
until the trouble
indication goes out. Do
not disconnect
machine from power
supply system to make
sure that the fan
operates.
▶ Do not expose the
electrofusion machine
to direct sunlight.
▶ Only operate the
electrofusion machine
in the permitted
temperature range.
For more information,
see chapter "Technical
data", page 40.
▶ Disconnect the mains
plug.
▶ Keep electrofusion
tool, all cables as well
as Geberit electro-
fusion coupling,
Geberit electrofusion
tape for anchor point
or Geberit electro-
fusion coupling with
integrated thermal fuse
dry and clean.
EN
49