Geberit ESG 3 Betriebsanleitung Seite 39

The Geberit ESG 3 electrofusion tool is equipped with
overvoltage protection, which protects the machine from
overvoltage damage.
With 230-volt mains operation
With the Geberit ESG 3 electrofusion tool and a mains voltage of
220 volts, it is possible to weld all Geberit electrofusion couplings
and Geberit electrofusion tapes for anchor point. Replacing the
coupling connection cable on the remote control also makes it
possible to weld all Geberit electrofusion couplings with integrated
thermal fuse.
The Geberit ESG 3 electrofusion tool also facilitates the serial
welding of up to three Geberit electrofusion couplings or Geberit
electrofusion tapes.
Possible dimensions are shown in the following table (see
page 393).
With 115-volt mains operation
With the Geberit ESG 3 electrofusion tool and a mains voltage of
115 volts, it is possible to weld all Geberit electrofusion couplings
and Geberit electrofusion tapes for anchor point.
The Geberit ESG 3 electrofusion tool also facilitates the serial
welding of up to three Geberit electrofusion couplings or Geberit
electrofusion tapes.
Possible dimensions are shown in the following table (see
page 393).
When operating with a power generator
When operating with a power generator, the Geberit ESG 3 electro-
fusion tool has the same functions as with mains operation. The
power generator must have an output of at least 2.5 kilowatts.
9962820747 © 01-2023
966.473.00.0(03)
EN
i ,
i ,
39