Geberit ESG 3 Betriebsanleitung Seite 48

EN
Malfunction
<Malfunction>
and
<Welding procedure>
LED displays
light up.
48
Cause
Defective
Geberit electro-
fusion coupling,
defective
Geberit electro-
fusion tape for
anchor point or
defective
Geberit electro-
fusion coupling
with integrated
thermal fuse.
Coupling
connection plug
removed during
the welding
procedure.
Rectification
▶ Disconnect the mains
plug.
▶ Visually inspect the
contacts on the
coupling connection
plugs and dry or clean
them if necessary.
▶ Use a new Geberit
electrofusion coupling,
a new Geberit electro-
fusion tape for anchor
point or a new Geberit
electrofusion coupling
with integrated thermal
fuse.
▶ Disconnect the mains
plug.
▶ Press the start button
and hold for three
seconds.
▶ Repeat the welding
procedure with a
cooled Geberit electro-
fusion coupling or
cooled Geberit electro-
fusion tape for anchor
point.
9962820747 © 01-2023
966.473.00.0(03)