Heiniger Trimmer StyleMidi Bedienungsanleitung Seite 18

maintenance must not be performed by chil-
dren without supervision.
Use only the original mains plug adapters.
If the power adapter (including the power cord)
is damaged, it must be replaced by the manu-
facturer or his customer service in order to
avoid hazards.
Observe the notes on cleaning and care of the
appliance (see "Cleaning and care" on
page 21).
After an extended use, the cutter head may be-
come hot.
DANGER as small parts may be swallowed
0-3
The lid of the oil bottle is a small part that could be swallowed. Keep away
from children under 36 months of age.
16 ENGLISH
DANGER for children
Packing materials are not children's toys. Children should not be allowed to
play with the plastic bags: there is a risk of suffocation.
DANGER! Risk of electric shock due to moisture
The following safety instructions apply to the connected charging station, and
to the appliance when it is being operated with the power supply unit.
Do not use this appliance or charging station close to baths, showers, wash-
basins or other containers containing water.
Never place the appliance anywhere that it could fall into water while plugged
in.
If the appliance has fallen into water, pull out the power supply unit immedi-
ately, and only then remove the appliance from the water. Do not use the
appliance again, and have it checked by a specialist workshop.
Protect the appliance from moisture, water drops and water splashes.
The appliance, the connecting cable, the charging station and the power sup-
ply unit must never be immersed in water or other liquids.
If liquid gets into the appliance, remove the power supply unit immediately.
Have the appliance checked before reusing.
Never touch the appliance with wet hands.
Do not rinse it under running water.
After use, pull out the power supply unit. The proximity of water represents a
hazard even when the trimmer is not being charged.
Installation of a residual current device (FI/RCD) with a rated residual operat-
ing current of no more than 30 mA into the electrical circuit is recommended