Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Replacing the cutter head
The cutter head 3 is a wear part. Despite good care, the cutting performance will
decrease at some point. Replace the cutter head when this happens. The cutter
head can be ordered separately as a spare part from the customer service cen-
tre. The address and telephone number of your nearest customer service centre
can be found on the back of these user instructions.
Cleaning the appliance
– From time to time, wipe the appliance with a slightly moistened cloth, then rub
dry.
Cleaning the charge contacts
If the charge contacts on the appliance 11 or the charge contacts on the charging
station 9 or the charge contacts on the plug of the connecting cable 14 are dirty,
charging may be interrupted or obstructed.
– Clean the charge contacts with a piece of cotton wool or cloth dipped in alco-
hol or methylated spirit.
– Dry the charge contacts before using them again.
Care of the battery
– Ensure that the appliance is switched off (LED in On/Off switch 1 is not lit)
when placing it in the charging station 8.
6
Service
Given the present state of the art, components of electrical appliances are sub-
ject to a certain degree of wear over time.
In order to ensure proper functioning and safety of the appliance, a regular check
must be performed in accordance with the country specific legal provisions -
though at least once every 2 years.
22
ENGLISH
7
Technical data
Product
Mains adaptor
Input
Output
Cutting length
Dimensions (L x W x H)
Weight (hand piece)
Power adapter
Published data
Ansmann AG
Industriestraße 10
97959 Assamstadt Germany
Reg. Amtsgericht: Ulm HRB B721168
Model identification: SEH0650900V / C20
Type: OC 20
Type: C20
100-240 V; 50-60 Hz
6.5V
/ 900 mA
adjustable: 0.5 - 2.4 mm
0.02 - 0.1 in
175 x 46 x 50 mm
6.89 x 1.81 x 1.97 in
240 g / 0.53 lbs
Value and
Unit
accuracy
–
–
–
–
Werbung
Inhaltsverzeichnis
