Bergstrom SLIMFIT RENAULT T High Sleeper Cab Diagnose Bei Ausfällen Seite 25

SLIMFIT
• Check and correct possible bad contacts, breakages or disconnection the LIN cable of
compressor 2.
• Correctly connect the module of compressor 2 or replace (to access the modules and
the compressors, remove the unit's external cover). Note: the references for each
module are different; check that it is replaced using the correct reference.
!
(If the error persists, contact the Authorised Technical Service).
• Reduce the tilt of the unit to a position of less than 45º. It is the electronic control that
detects the tilt of the unit and prevents its operation so that no damage is caused to the
compressor.
• Replace compressor 2.
• Correctly connect the module of compressor 2 or replace (to access the modules and
the compressors, remove the unit's external cover). Note: the references for each
module are different; check that it is replaced using the correct reference.
!
(If the error persists, contact the Authorised Technical Service).
• Check compressor terminal connections or possible cuts in cables.
• Connect cable clamps in the electronic control.
• Check that the references of each of the modules are different.
!
(If the error persists, contact the Authorised Technical Service).
Solution
25
EN