Bergstrom SLIMFIT RENAULT T High Sleeper Cab Diagnose Bei Ausfällen Seite 24

SLIMFIT
EN
Symptom
• While the unit is in operation, warning
(compressor 2 communication
error) is displayed on the control panel
and the unit switches off automatically.
The warning will be displayed on the
control panel until the anomaly is
repaired.
• When the unit has a tilt of more than 45°
(e.g. with the cab down) the control panel
will display warning
• (compressor 2 overheating error)
is displayed on the control panel, the
unit switches off automatically. The
warning will be displayed on the control
panel until the anomaly is repaired.
• When the unit is switched on or during
operation,
connection error), is shown on
the display, the unit switches off
automatically. The warning will be
displayed on the control panel until the
anomaly is repaired.
(unit tilt error).
(communication
• Compressor 2 LIN cable disconnected,
has bad contact or faulty.
• Compressor 2 module disconnected
from compressor or faulty.
• Unit slant 45º or over.
• Compressor 2 faulty or broken.
• Compressor 2 module disconnected
from compressor or faulty.
• Poor connection in compressor module
cables or terminals.
• Communication cable poorly connected
or disconnected from the electronic
control.
• Compressor modules not compatible.
24
Cause