Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The router is located in the installation box on a top-hat rail. Open the installation
box and remove the router. To do this, unscrew the antenna cable and pull the
plug of the power cable and the plug of the Ethernet cable out of the router. Then
detach the router from the top-hat rail.
Insert your SIM card and carry out the initial configuration of the router. You will
find more detailed instructions on how to proceed in the router's manual. Use the
supplied 230 V power cable and antennas to commission and test the router for
the configuration process.
During the initial configuration process, you can make various settings for the
Internet connection. You will also need to unlock the PIN of the SIM card you are
using.
Once you have completed the initial configuration of the router, make sure that
the Internet connection via the router works. Test this e.g. via the WLAN function
and a smartphone.
When you are sure that the router is configured and an Internet connection is
established, unscrew the rod antennas and disconnect the 230 V power cable
from the router.
Then fix the router back on the top-hat rail in the installation box and screw on the
prepared cables of the antenna integrated in the cube.
Then plug the prepared power cable and the prepared LAN cable (RJ45) into the
router.
Close the installation box again.
Please read the operating instructions on the integrated solar charge controller
carefully before installing and connecting the load and solar modules.
Depending on the equipment of your ProCube, loads and PV modules are connected
differently.
Page 54
Commissioning
Werbung
