Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Stand-alone mode
Automatic mode
In automatic mode, 20 different show programs are available that run at an adjustable speed.
1
Press the MENU button so many times until AUTO for automatic mode is indicated in the display. Confirm with
the ENTER button.
2
Use UP and DOWN to select the number of the desired program. Confirm with ENTER.
3
The display indicates FADE. Use UP and DOWN to set a color switch or color fade effect. Confirm with
ENTER.
4
The display then indicates the menu item running speed. Use UP and DOWN to adjust the running speed of
the program from S.01 (slow) to S.099 (fast). Confirm with ENTER.
5
Next you can set the brightness of the spots, the derby, the UV-LEDs and the scanners individually. Use UP
and DOWN to adjust the desired brightness from d.01 (dark) to d.100 (bright). Confirm with ENTER.
Sound control
Via the integrated microphone the unit can perfectly reproduce the 20 show programs to the rhythm of the music
(sufficient bass provided).
1
Press the MENU button so many times until SOUND for sound control is indicated in the display. Confirm with
the ENTER button.
2
Use UP and DOWN to select the number of the desired program. Confirm with ENTER.
3
The display indicates FADE. Use UP and DOWN to set a color switch or color fade effect. Confirm with ENTER.
4
Next you can set the brightness of the spots, the derby, the UV-LEDs and the scanners individually. Use UP
and DOWN to adjust the desired brightness from d.01 (dark) to d.100 (bright). Confirm with ENTER.
5
Use the rotary control SENSITIVITY to adjust the microphone sensitivity to the sound volume. In case of
missing sound signal, the LEDs are either switched off after 5 seconds or hold the most recent light effect. This
function can be found under the menu item SETUP > SOUND.
Manual mode
The mode COLO allows each of the lighting effects to be individually adjusted.
1
Press the button MENU so many times until COLO is indicated in the display. Confirm with the ENTER button.
2
Select the desired lighting effect unit (PAR 1 – PAR 4, Derby, or Pan, Tilt, Color, Gobo for the scanners)
using the UP and DOWN buttons. Confirm with ENTER.
3
In PAR 1 – PAR 4 and Derby mode, the display indicates the letter R for the color red and the corresponding
intensity value.
4
Use the UP and DOWN buttons to adjust the desired intensity.
5
Confirm with ENTER. Now the color green can be adjusted; then blue and white.
6
In Pan, Tilt, Color, Gobo mode, you can select the desired pan and tilt settings of the scanner mirrors. Color,
Gobo allows you to choose the desired color and gobo. Confirm each selection with ENTER.
7
The setting for total brightness can be done under menu point Dimmer. Use UP and DOWN to select the
desired brightness from 000 (0%) to 255 (100%). Confirm with ENTER.
8
The strobe setting for the derby and spots is the last menu item. Use the buttons UP and DOWN to adjust the
flash frequency from 000 (slow) to 255 (fast).
43/60
00143808, Version 1.0
Werbung
Inhaltsverzeichnis
