Use Procedure; Pump Shutdown - Varian Turbo-V 70 Bedienungshandbuch

Left panel

USE PROCEDURE

Controller and Pump Startup
To startup the controller and the pump apply mains to
P17 connector.

Pump Shutdown

To stop the pump, you need to set jumpers b7-a5 on
P17 connector, or press the STOP button on the Hand
Held Terminal if the controller is configured in FRONT
Mode.
MAINTENANCE
The Turbo-V 70 series controller does not require any
maintenance. Any work performed on the controller
must be carried out by authorized personnel. When a
fault has occurred it is possible to use the Varian repair
service. Replacement controllers are available on an
advance exchange basis through Varian.
!
Before carrying out any work on the controller,
disconnect it from the supply.
All manuals and user guides at all-guides.com
Right and left panels of controller 969-9506
WARNING!
Right panel
If a controller is to be scrapped, it must be disposed of
in accordance with the specific national standards.
Meaning of the "WEEE" logo found in labels
The following symbol is applied in accordance with the
EC WEEE (Waste Electrical and Electronic Equipment)
Directive.
This symbol (valid only in countries of the European
Community) indicates that the product it applies to
must NOT be disposed of together with ordinary
domestic or industrial waste but must be sent to a
differentiated waste collection system.
The end user is therefore invited to contact the supplier
of the device, whether the Parent Company or a
retailer, to initiate the collection and disposal process
after checking the contractual terms and conditions of
sale.
67
INSTRUCTIONS FOR USE
DISPOSAL
87-900-870-01 (E)