Use Procedure; Controller Startup; Starting The Pump; Pump Shutdown - Varian Turbo-V 70 Bedienungshandbuch

1
2
3
1. Logic input signals connectors (mating connector supplied with link).
2. Logic output signals connector and pump current monitor.
3. Power output connector (24 Vdc for pump cooling fan).
4. Connector to the pump cable.
5. Controller power entry module consisting of mains fuses, voltage change over, mains socket
and EMC filter.
6. Power output connector (120 Vac) for vent device, forepump contactor coils, etc.
7. Provision for RS232 communication port connector (provided as an option).
8. Hand Held Terminal link connector.

USE PROCEDURE

Controller Startup

To startup the controller plug the power cable into a
suitable power source.

Starting the Pump

To start the pump press the START pushbutton on the
hand held terminal.
5
6
Left Panel
Controller 969-9507 Right and Left Panels
7
4

Pump Shutdown

To shutdown the pump press the STOP pushbutton on
the hand held terminal.
MAINTENANCE
The Turbo-V 70 series controller does not require any
maintenance. Any work performed on the controller
must be carried out by authorized personnel.
47
INSTRUCTIONS FOR USE
Right Panel
87-900-869-01 (B)
8