Instructions For Use - Varian 929-0200 Bedienungshandbuch

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

GENERAL INFORMATION

This equipment is destined for use by professionals.

The user should read this instruction manual and any

other additional information supplied by Varian before

operating the equipment. Varian will not be held

responsible for any events occurring due to non-

compliance, even partial, with these instructions,

improper use by untrained persons, non-authorised

interference with the equipment or any action contrary

to that provided for by specific national standards. The

MicroVac is a high voltage and low power feeder used

to feed the ionic pumps; it is equipped with a

microprocessor used to control the front panel.

In addition to the connector to feed the pump, there is

also a jack acting as an interlock; if it is not inserted

into the output connector, no voltage is present.

The following paragraphs contain all the information

necessary to guarantee the safety of the operator when

using the equipment. Detailed information is supplied in

the section "Technical Information".

This manual uses the following standard protocol:

The warning messages are for attracting the attention

of the operator to a particular procedure or practice

which, if not followed correctly, could lead to serious

injury.

The

caution

messages

procedures which, if not followed, could cause damage

to the equipment.

The notes contain important information taken from the

text.

STORAGE

When transporting and storing the MicroVacs, the

following

environmental

satisfied:

•

temperature: from -20 °C to + 70 °C

•

relative humidity: 0 - 95%

(without condensation)

WARNING!

CAUTION!

are

displayed

before

NOTE

requirements

should

PREPARATION FOR INSTALLATION

The controller is supplied in a special protective

packing. If this shows signs of damage which may have

occurred during transport, contact your local sales

office. When unpacking, ensure that the module is not

dropped or subjected to any form of impact. Do not

dispose of the packing materials in an unauthorised

manner. The material is 100% recyclable and complies

with EEC Directive 85/399.

Each controller is factory set for a specific power

supply:

•

model

929-0201

connector (220 Vac, 50/60 Hz)

•

model

929-0200

connector (120 Vac, 50/60 Hz)