Use Procedure; Pump Shutdown - Varian Turbo-V 250 969-9504 Bedienungshandbuch

Left panel

USE PROCEDURE

Controller and Pump Startup
To startup the controller and the pump apply mains to
P17 connector.

Pump Shutdown

To stop the pump, you need to set jumpers b7-a5 on
P17 connector, or press the STOP button on the Hand
Held Terminal if the controller is configured in FRONT
Mode.
Right and left panels of controller 969-9504
47
Right panel
MAINTENANCE
The Turbo-V 250 series controller does not require any
maintenance. Any work performed on the controller
must be carried out by authorized personnel. When a
fault has occurred it is possible to use the Varian repair
service. Replacement controllers are available on an
advance exchange basis through Varian.
!
Before carrying out any work on the controller,
disconnect it from the supply.
If a controller is to be scrapped, it must be disposed of
in accordance with the specific national standards.
INSTRUCTIONS FOR USE
WARNING!
87-900-856-01 (B)