Installation Of The Gas Linkage; Connection And Replacement Of The Gas Cylinder (Lpg Version) - Planika Kl21 Rio Montage- Und Bedienungsanleitung

3.5. Installation of the gas linkage

WARNING!!! The montage and service needs to be conducted by a qualified professional, a company or the gas
supplier.
Before proceeding with the connection of the gas cylinder to the fireplace all activity regarding the correct placement
and installation of The Rio needs to be already performed. Place the gas linkage away from hot or sharp edges and
make sure it is not twisted.

3.5.1. Connection and replacement of the gas cylinder (LPG version)

The Rio is delivered together with an elastic gas linkage which, on one end is connected to the valve of the device and
one the other end to the gas regulator ready to be connected to the gas cylinder.
Pressure reducer type
Type A
Type B
Type C PL, DE, LT, AL, BE, CZ, SK, SI, LV, HR, CH, UA, RS, MK, BiH
Type D
If your gas cylinder has a different inlet size or requires a different regulator, replace the included regulator with the
required one (available separately at your local market)
WARNING!!! NEVER use an unstable gas connection or a regulator for other gas pressure.
Gas cylinders have two types of connectors:
•
Twist-on connection: The most important thing is the black seal. Always check if the seal is present and that it
hasn't been damaged during the gas cylinder replacement. Some connections have a knob to fasten them in
place while others require the use of a wrench. Tighten securely (left thread). Using the tool pay attention not
to fasten the connection too tightly as this may damage the seal.
Quick-release: For this type of connection no tool is required. On/off regulation of gas connection is made through a
switch on the regulator or on a special connector. In case of using a connector with a thread regulator of an old type
put a special emphasis on checking if the connecting nut has been tightly fastened with the help of wrench
Country
FR, UK, IE
ES, DK, NO, FI, EE, PT, CY
IT, GR
Connection Type
Clip On
Clip On
Twist On
Twist On
7
Inlet Diameter Output
27 mm G1/4"-LH
35 mm G1/4"-LH
23 mm G1/4"-LH
20 mm G1/4"-LH