Installation; Box Contents; Unboxing And Installation - Planika KL21 Rio Montage- Und Bedienungsanleitung

3.

INSTALLATION

3.1. Box contents

•
1x complete Rio gas fireplace
•
2x Tempered glass screen
•
4x small glass holders
•
4x adjustable legs
•
1x AAA Batteries (placed under the ignition button)
•
1x box of decorative stones
•
1x 4 metre rubber gas linkage – installed
•
1x pressure regulator (37mbar) – installed
•
1x installation manual and user's manual

3.2. Unboxing and installation

• The contents of the boxes need to be carefully unwrapped from the foam foil.
• Remove the bags with decorative stones from the burner reservoir and place them away from it.
• Remove the Styrofoam placed on the unit.
• Carefully lift the appliance and pull out the glass shield wrapped in cardboard from the inside of the Rio.
• Check the completeness of the elements with the contents list.
• Make sure that the device nor its elements weren't damaged during the transportation (if they were, notify the
supplier).
• Place Rio on a flat, paved surface outside of the building, preferably on the place of final installation. Leave
sufficient space on the side of the appliance where control panel is located (minimum 1 m).
• The decorative stones are to be scattered evenly around the reservoir to completely cover the burner of the
fireplace.
• Install carefully the side glass shields (See point 3.3).
• If all the points were completed according to the instruction the gas bottle can be now connected
Fig. 2
– RIO top view and ignition elements detail
5