Installation Of Glass Screens And Adjustable Legs; Gas Cylinder Montage (Only Lpg Version) - Planika KL21 Rio Montage- Und Bedienungsanleitung

3.3. Installation of glass screens and adjustable legs

• Carefully remove cardboard and foam foil from the
glass screens.
• Remove all contaminations from the glass shields
which could burn out on the glass during operation
of The Rio (in particular fingerprints).
• Install glass shields and adjustable legs in the
corresponding slots on the appliance as shown
below
• Remove the glass shield only in case of damage of
the glass.

3.4. Gas cylinder montage (only LPG version)

• The gas linkage attached to the device allows to place the gas bottle maximally 3 meters away from the
connected control panel, however it cannot be placed closer to the device than 1,5 meters. You can follow the
local regulations if it provide different distance requires.
•
The optional housing for the gas bottle cannot be airtight and has to be correctly ventilated. The housing needs
to have an upper ventilation slot above the top of the bottle (of an area min 1/100 of the area of the base of
the housing) and a lower ventilation slot (of an area min 1/50 of the area of the base of the housing). The
dimensions of the housing may vary to accommodate different types and dimensions of the gas bottles
however they also have to be sufficient for hassle-free installation of the gas bottle.
Fig. 4
– Gas cylinder distance and housing for gas cylinder
Fig. 3
6
– Glass installation