Regulation Of The Flame Size; Device Shutdown - Planika Kl21 Rio Montage- Und Bedienungsanleitung

•
While keeping the knob still pressed start the flame by pressing the ignition button (3).
•
A spark will appear which ignites the main burner on the minimum flame height. If the flame did not ignite
repeat this process 2-3 times. This will be required especially when you have replaced and installed a new LPG
gas cylinder.
•
When the flame is ignited keep holding the knob for around 5 seconds until the thermo-couple, which will
keep the main valve in an open position, warms up.
•
You may now release the knob. If however the flame is extinguished repeat the process once again until a
stable flame is achieved.
WARNING!!! After 2-3 unsuccessful attempts terminate and check the connections. Try again in 10 minutes. If the
installed gas bottle is new or the fireplace has not been used for a longer pe Riod the first thing that needs to be done
is to release air from the gas linkage. In this case conducting a few attempts will be needed until the flame is ignited.

4.3 Regulation of the flame size

•
When the flame is burning the desired height of the flame may be adjusted and regulated by turning the knob
clockwise or counter-clockwise.
•
To achieve a higher flame turn the know clockwise to "Hi" position. To achieve a lower flame turn the knob
counter- clockwise to "Lo" position (Fig. 9).

4.4 Device shutdown

•
To turn off the device, simultaneously press and turn the knob all the way clockwise. The gas supply will be
cut and the flame on burner will be turned off.
•
Additionally, close also the valve on the gas cylinder.
Fig. 8
– Ignition sequence
Fig. 9
– Flame regulation
Fig. 10
– Turning the device off
12