SOLARWATT Vision 60M construct Montageanleitung Seite 23

NOTE
Get the static qualification of the building checked for the installation of a solar
system by qualified personnel.
NOTE
Do not remove any parts or nameplates from the solar module. Do not install
damaged solar modules.
Also not allowed are modifications of the solar module, such as the conversion to the use
of the heat generated in the form of a thermal solar collector. If there is no approval in
the form of a manufacturer's declaration or exceptional approval, the solar modules may
not be installed in locations where there are aggressive ambient conditions. Furthermore,
the use of the products on mobile units such as vehicles or ships is not permitted.
Make sure that there are no components such as cable ties, fasteners or similar materials
between the mounting rails and the backside of the module. When the modules are in-
stalled vertically (portrait), the bottom row modules must be positioned with the junction
box towards the ridge.
During installation, avoid creating shades with the module clips or installation system to
improve the energy yield.
Comply with the minimum distance of 5 mm between the solar modules to allow the
material to expand without tension. For system documentation, note the positions of the
modules and their serial numbers. Before commissioning, a final inspection of the entire
system is recommended.
WARNING
The solar module is a glass product and should be handled with appropriate
care. Do not stand on the solar module. Do not allow any objects to fall or place
any objects on the solar module, as it can cause microcracks in the cells. Never
hold or transport the solar module by the junction box or connection cables. For
installation Solarwatt strongly recommends the usage of clean, fat and silicone
oil free gloves!
Subject to change | © 2022 Solarwatt GmbH 23