Meec tools 019478 Bedienungsanleitung Seite 38

EN
STARTING/STOPPING
WARNING!
The disc continues to rotate after the motor is
switched off.
1. Press the back part of the power switch
(arrow 1).
2. Move the power switch forward (arrow 2).
3. Stop the angle grinder by pressing the
back part of the power switch (3).
When the product is switched off the power
switch automatically goes to the O position.
Wait until all moving parts have completely
stopped before putting down the product.
FIG. 9
MAINTENANCE
WARNING!
• Risk of electric shock.
• Pull out the plug before cleaning.
• Remove dust and dirt with a cloth
moistened with detergent. Make sure that
no water gets into the product.
• Clean the ventilation openings with a
brush. The product is permanently
lubricated and does not need further
lubrication.
• Check the carbon brushes at regular
intervals and replace them when they are
worn down to 1/3.
NOTE:
Do not use strong detergent or solvent, they
can damage the plastic parts on the tool.
Clean with a soft cloth moistened with a
mild detergent. Do not expose the product to
water or any other liquid.
38