Meec tools 019478 Bedienungsanleitung Seite 34

EN
the disc to recoil and kick back. The disc can
jump either towards or away from the user,
depending on the direction of rotation of
the disc when it jams. Grinding discs can also
break in these situations. Kickback is a result
of the incorrect use of the power tool, and/
or incorrect procedures or working conditions.
Kickback can be avoided by observing the
safety measures described below:
1. Keep a firm grip on the tool and position
your body and arm so you can resist
the force of a sudden kickback. Always
use the support handle, if there is one,
for maximum control of the kickback or
torque response when starting the tool.
The user can control torque response and
kickback if the appropriate precautions
are taken.
2. Never put your hands near the rotating
accessory. Kickback can cause the
accessory to touch your hand.
3. Keep your body away from the area
where the power tool will go if there is a
kickback. Kickback forces the tool in the
opposite direction to the rotation of the
disc.
4. Take extra care when working on corners
and sharp edges, etc. Avoid letting the
accessory bounce or catching. Corners,
sharp edges and bouncing can cause the
rotating accessory to catch and cause the
user to lose control of the tool, or cause it
to kick back.
SPECIFIC INSTRUCTIONS FOR
GRINDING AND ABRASIVE CUTTING
• Use only the types of disc recommended
for your power tool and the specific guard
designed for your chosen disc. Discs that
the tool is not designed for cannot be
properly protected and are therefore not
safe.
• The grinding surface on discs with a
recessed centre must be fitted below the
34
plane of the protective flange. An
incorrectly fitted disc that projects through
the plane of the guard flange cannot be
properly protected.
• The guard must be firmly fixed to the
power tool and positioned for maximum
safety, so that the smallest possible part
of the disc is exposed to the user. The
guard helps to protect the user against
broken-off fragments of disc, accidental
contact with the disc, and sparks that
could set fire to clothing.
• Discs must only be used for the
recommended applications. For example:
Do not grind with the side of a cutting disc.
Abrasive cutting discs are intended for
grinding with the outer edges. If lateral forces
are applied to these discs, they can shatter.
• Always use undamaged disc flanges of the
right size and shape for the disc you have
chosen. Correct disc flanges support the
disc and therefore reduce the risk of the
disc breaking. Flanges for cutting discs can
differ from flanges for grinding discs.
• Do not use worn down discs from a larger
power tool. Discs from larger power tools
are not suitable for the higher speeds of
small tools and can shatter.
SAFETY INSTRUCTIONS FOR
BONDED GRINDING DISCS
Grinding discs can break and are sensitive to
impact and pressure. For this reason take the
following precautions when handling grinding
discs:
1. Do not drop grinding discs or subject
them to knocks and blows.
2. Do not use damaged grinding discs or
discs that have been dropped.
3. Avoid damaging the centre hole.
4. Do not subject grinding discs to heavy
weights; do not put anything on top of
them.
5. Store grinding discs flat, or upright in a
dry and frost-free place.