Repair Using The Crystal Technique - invicon StoneLux 2.0 Gebrauchsinformation

Note: For larger damaged areas, move the lighting unit slowly over the damaged area.
Warning: only use the blue:tron
Note: Alternatively, black screen dots or lines can be placed using the retouching pen after the curing process.
5. Fill the damaged area with StoneLux
See Step 3.
Note: Overfill the damaged area slightly.
®
Note: StoneLux 2.0 transpa is slightly yellowish in colour. After being fully light-cured, the material will be completely
colourless and transparent.
Next step 4.6. Finish the repair, page 17

4.3. Repair using the crystal technique

1. Place the application cannula on the StoneLux
2. Apply the material to the transparent mixing plate, mix in suitable StoneLux
the original colours of the repair surface.
The following crystal
variants are available:
12 | invicon StoneLux® 2.0
® when wearing safety goggles
® 2.0 transpa up to the upper edge and slightly overfill. Then light cure as usual.
®
2.0 repair syringes and tighten.
Crystal colour
X1
fine
transparent x
white x
black x
®
2.0 structure crystals and compare with
Crystal size
X2 X3 X4
medium coarse extra coarse
x x x
x x x
x x x