Repair Using The Retouching Technique - invicon StoneLux 2.0 Gebrauchsinformation

4.2. Repair using the retouching technique

1. Place the application cannula on a suitable StoneLux
2. Apply the material to the transparent mixing plate, mix using the application instrument and compare with the original
colours of the repair surface. If necessary, repeat the mixing process until the target colour is achieved.
3. Depending on the original colour of the repair surface, apply the mixed individual StoneLux
of the application instrument over the entire surface or finely screen in spots with the tip.
Warning: Light curing materials like StoneLux
exposure process. To achieve the desired thickness, it may be necessary to apply several layers of material and systematically
cure each of them.
Warning: The maximum coat thickness for each colour can be found on page 21.
Note: It is not necessary to apply primer between the individual StoneLux
Note: When mixing 2 colours, always use the lighter colour as the base and carefully mix in the darker colour
to avoid large loss of material.
4. Carefully position the blue:tron
®
Note: The blue:tron lighting unit has a safety distance and only comes on when this distance is observed.
Alternatively: Carefully place the red blue:tron
the blue:tron ® lighting unit into the upper opening of the glare shield. Then turn the light on for 60 seconds.
® 2.0 colour repair syringe and tighten.
® 2.0 black, brown, red and yellow cure to different depths after one
®
lighting unit with the LED lighting head. Then turn the light on for 15 seconds.
® glare shield over the damaged area and carefully lock the LED lighting head of
®
2.0 colour with the spatula side
®
2.0 coats.
invicon StoneLux® 2.0 | 11