Repair The Damage; Repair Using The Transpa Technique - invicon StoneLux 2.0 Gebrauchsinformation

4. Repair the damage

There are 5 different repair techniques to choose from depending on the starting situation and the material.

4.1. Repair using the transpa technique

1. Place the application cannula on the StoneLux
2. Carefully squeeze out the StoneLux
Note: Overfill the damaged area slightly
®
Note: StoneLux 2.0 transpa is slightly yellowish in colour.
After being fully light-cured, the material will be completely colourless and transparent.
3. Cover the filled-in damaged area with StoneLux
4. Carefully position the blue:tron
Note: The blue:tron ® lighting unit has a safety distance and only comes on when this distance is observed.
Alternatively:
Carefully place the red blue:tron
®
blue:tron lighting unit into the upper opening of the glare shield. Then turn the light on for 60 seconds.
Note: For larger damaged areas, move the lighting unit slowly over the damaged area.
Warning: only use the
blue:tron
Next step 4.6. Finish the repair, page 17
10 | invicon StoneLux® 2.0
® 2.0 transpa repair syringe and tighten.
®
2.0 transpa repair material and insert into the damaged area.
®
2.0 transparent film. (Do not press on!)
® lighting unit with the LED lighting head on the transparent film. Then turn the light on for 15 seconds.
®
glare shield over the damaged area and carefully lock the LED lighting head of the
®
when wearing safety goggles.