8.3 Removing and fitting the driving belts
38
Removal:
–
Remove the position transmitter, the hand wheel and the belt
guard.
–
Remove the belt jump guard.
–
Erect the machine and remove the driving belt.
–
Loosen the screw 1 and shift the complete belt pulley unit 2.
–
Remove the toothed belt.
Fitting:
–
Install both toothed belts.
–
Push the belt pulley unit outwards ( tightening the toothed belts )
and tighten the screw 1.
–
Fit the belt jump guard.
–
Fit the belt guard, the hand wheel and the position transmitter .
NOTE
Check hook settings and proceed to a new adjustment, if required,
see chapter 3. Hook and needle bar.
2
1