Plug-In Side Panels With Height Adjustment (Optional); Backrest Angle; Backrest (Standard); Angle-Adjustable Backrest (Optional) - B+B BX 11 Bedienungsanleitung

BX 11 | BX 11 S
| Adaptive wheelchair
4.3.2. Plug-in side panels with height
adjustment (optional)
2
The pluggable side sections are equipped with height-adjustable arm-
rests. You can remove the side part completely.
Armrest height
• Press the push-button at the lower end of the tube and adjust the
19
1
armrest to the desired height (Fig.19.
• Release the push button so that the armrest locks into the next
possible position.
Removing the side panels
• Press the push-button at the lower end of the tube and pull the
section completely out of the lock (Fig. 19a).
To assemble, push the side part into the lock and adjust the armrest to
the desired height. The side part must engage audibly.
6919a

4.4. Backrest angle

4.4.1. Backrest (standard)

+9° -15°
The backrest of your wheelchair is not adjustable. The backrest angle is
90° to the seat surface.
20
4.4.2.
(optional)
The optional backrest of the wheelchair can be adjusted in angle (Fig.
20).
80
Angle-adjustable Backrest
Your dealer will tell you how to adjust the backrest in
the assembly instructions.
Adaptive wheelchair |

4.5. Push handle height

4.5.1. Push handles (standard)

The push handles can be adjusted to a comfortable position for the
accompanying person. The backrest height and the back sag must then
be adjusted.
For further adjustment options, please consult the
installation instructions of your dealer.

4.5.2. Push handles (optional)

• The optional push handles can be adjusted to the individual height
of the accompanying person, independently of other adjustments.
• Release the lock (Fig. 21).
• Set a comfortable height for the accompanying person.
• Tighten the lock again.

4.6. Fitting seat and back

4.6.1. Seat sag

The seat of your wheelchair can be retightened. Always tighten it suf-
ficiently. Nevertheless, make sure that there is enough slack in the pel-
vic area.
• If present, first remove your seat cushion.
• Undo the Velcro Fastener under the seat
• Pull the seat upholstery as tight as desired and tighten with the
Velcro Fastener (Fig. 22).
• Put your seat cushion back on the seat.
Bischoff & Bischoff GmbH 2023-01-19 - Revision: 2
BX 11 | BX 11 S
21
22
81