Horizontally Adjustable Leg Supports (Optional); Amputation Leg Support (Optional); Active Side Panels - B+B BX 11 Bedienungsanleitung

BX 11 | BX 11 S
| Adaptive wheelchair
Adjusting the legrest length
The foot plates can be adjusted 5 times in 20 mm steps to the length
of the lower leg.
• To do this, remove both hexagon socket screws on the leg support
tube (inside and outside) and adjust to the desired length (Fig. 16).
- Tighten the screws again.
16
Angle adjustable foot plates
2
The angle of the foot plates can be adjusted (Fig. 17).
• Unscrew the hexagon socket screw.
• Turn the sprocket to set the foot plate in the desired position.
• - Tighten the screw again.
2
1
17
4.2.3. Horizontally adjustable leg
supports (optional)
Assembly, disassembly and swivelling are carried out in the same way
as for the standard leg supports. To adjust, loosen the clamping lever,
then adjust the legrest to the desired length and tighten the clamping
lever
The horizontal adjustment works as follows:
• push the locking lever forward.
• by raising or lowering the footplate support tube, bring the legrest
into the desired position.
• Release the locking lever; the legrest locks automatically.
78
Never climb onto the foot plate and watch your fin-
gers when swivelling, there is a danger of getting
caught.
Adaptive wheelchair |
Before driving off, make sure that the legrests are
firmly seated!
Make all settings the same on both sides.
The legrest must be swivelled away or removed in
order to sit down. Never sit on the legrest. Danger
of tipping over!
4.3. Amputation leg support (optio-
nal)
Assembly, disassembly and swivelling are the same as for the standard
legrests, adjustment is the same as for the adjustable legrests, and
horizontal adjustment is the same as for the horizontally adjustable
legrests.

4.3.1. Active side panels

The wheelchair is equipped with an aluminium clothes guard as stan-
dard (Fig. 18). This is attached to the front and rear of the frame. The
height of the clothes guard must be adjusted if the seat position or the
tyre size is changed.
Your dealer will tell you how to adjust the clothes
guard in the assembly instructions.
Bischoff & Bischoff GmbH 2023-01-19 - Revision: 2
BX 11 | BX 11 S
18
79