Electronic Adjustment Functions; Sidepanels; Arm Support; Adjusting The Height - B+B Triplex Bedienungsanleitung

TRIPLEX
| Electric Wheelchair
3.5.4. Electronic adjustment
functions
Depending on the configuration it may also be possible to adjust the
angle of the seat, back support and foot support electronically. For
further details, see chapter 4, "Using the wheelchair".

3.5.5. Sidepanels

You can slide the sidepanels sideways.
• Undo the fastening screw underneath the seat and slide the side
part into the desired position (fig. 10).
• Tighten the screw again.
10
48
Beware of the risk of to the user, carer and third
parties when electronically adjusting the seat
functions.
Make sure the fastening is firmly tightened.
Electric Wheelchair |

3.5.6. Arm support

The arm support can be completely removed to be able to get in and
out of the wheelchair from the side. In addition, the height of the
arm support can be adjusted. They can also be adjusted sideways by
adjusting the sidepanels (see sidepanels).
Removing the arm support
• To remove the arm support, loosen the bolt and pull out the arm
support to the top (fig. 11).
• When installing the arm support, make sure it is inserted all the
way and fastened again.

Adjusting the height

• First take the arm support out of the mounting.
• Remove the arresting bolt and screw it back into the arm support at
the desired position (fig. 12).
• The lowest hole represents the maximum height of the arm support.

3.5.7. Control unit

• The control unit can be mounted either on the right or left-hand
side underneath the arm support each.
• The control unit must be adjusted by a qualified mobility dealer to
warrant safe functionality of the wheelchair.
Adjusting the height
• The distance to the arm support can be adjusted.
• Loosen the screw connection on the inner side of the side part.
(fig. 13)
• Move the control unit into the desired position, then tighten the
screw again.
Bischoff & Bischoff GmbH | 05.10.2020 - Revision: 1
TRIPLEX
11
12
13
49