Meec tools 022532 Bedienungsanleitung Seite 47

the red emergency switch must be lifted
for the green power switch to become
accessible.
• In an emergency the router can quickly be
switched off with the emergency stop button.
• In the event of a power failure the
magnetic mechanism in the safety switch
ensures that the router does not start
again when the power returns.
Parts
Safety switch (2), bag 2 with 2 screws (14), 2
washers (15), 2 nuts (16).
1. Place the safety switch (2) on the front of
the worktop as shown in the figure.
FIG. 17
2. Fit in place with the supplied screws (14),
washers (15) and nuts (16).
FIG. 18
Fitting the fence
Parts
Fence (1), bag 3 with 2 thumb screws (17), 2
washers (18), 2 nuts (19).
1. Place the fence (1) on the worktop (7) and
insert the thumb screws (17) through the
slots in the fence and holes in the worktop
as shown in the figure.
2. Fix the fence in place with the supplied
washers (18) and nuts (19).
3. Always check that the safety devices are
working properly after fitting the fence.
FIG. 19
Fitting the spring fences
Parts
Bag 1 with 3 spring fences (9), 4 carriage bolts
(19), 4 washers (11), 4 wing nuts (12), 2 thumb
screws (13).
WARNING!
If the spring fences are fitted incorrectly there
is a risk of the workpiece being thrown out
and causing serious personal injury.
1. Place the middle spring fence with the
springs turned to the fence.
FIG. 20
2. Place the left and right spring fences with
the springs turned to the worktop.
FIG. 21
Always fit the middle spring fence on the
worktop first, before the rest.
Fitting the middle spring fence
3. Place the middle spring fence (9) on the
worktop.
4. Align the slots in the spring fence to the
holes in the worktop as shown in the figure.
5. Put the thumb screws (13) through the
slots in the spring fence and into the
threaded holes in the worktop.
FIG. 22
Fitting the left and right spring
fence
6. Place the left and right spring fence (9)
beside the holes for fitting the fence (1).
7. Put the carriage bolts (10) through the
slots in the spring fence and into the holes
in the fence.
8. Fix the spring fence firmly in place with the
supplied washers (11) and wing nuts (12).
FIG. 23
Where appropriate remove dust extraction
adapter from the router before it is installed on
the product.
The product has a dust extraction port and
dust extraction adapter. Follow the instructions
below to fit the dust extraction adapter.
9. Put the dust extraction adapter (8) in the
dust extraction port (A) behind the fence (1).
10. Connect the product to the dust extraction
device by connecting a hose to the dust
extraction adapter.
FIG. 24
EN
47