Unpacking And Inspection - Meec tools 022532 Bedienungsanleitung

Bag 1:
9. Spring fence, 3x
FIG. 2
Bag 2:
10. Carriage bolt, 4x
11. Washer, 6x
12. Wing nut, 4x
13. Thumb screw, 2x
FIG. 3
Bag 3:
14. Screw, 18x
15. Washer, 18x
16. Nut, 18
FIG. 4
Bag 4:
17. Thumb screw, 2x
18. Washer, 2x
19. Nut, 2x
FIG. 5
Bag 5:
20. Clamp, 4x
21. Carriage bolt, 4x
22. Washer, 4x
23. Nut, 4x
FIG. 6
Bag 6:
24. C-clamp
FIG. 7
ASSEMBLY

UNPACKING AND INSPECTION

1. Unpack the product.
2. Check that no parts are missing (see list of
supplied parts).
3. Check that none of the parts are
damaged.
4. Do not use the product if any parts are
missing or damaged. Contact the retailer.
ASSEMBLY
Fitting the legs and side tables
Parts
Worktop (7), 4 legs (6), 2 side tables (5), bag 2
with 16 screws (14), 16 washers (15),
16 nuts (16).
Tools
Spanner 8 mm, Phillips screwdriver #2
1. Place the worktop (7) upside down on
a stable surfaces and arrange the side
tables (5) and legs (6) as shown in the
figure below.
FIG. 8
2. Screw the leg and side table onto the
worktop with the spanner and screwdriver,
with the supplied screws (14), washers
(15) and nuts (16).
3. Repeat for the other legs and side table.
Check that the legs and side tables are
firmly fitted before the next step.
FIG. 9
It is easier to install the required bit, adjust the
bit depth and lock the router power switch in
switched on mode before the router is installed
on the product.
IMPORTANT:
Always feed the workpiece to the bit in
the opposite direction to the direction of
rotation of the bit. Check that the arrow for
the direction of rotation on the router points
in the same direction as the arrow on the
product (see figure).
Arrow for direction of rotation on table.
FIG. 10
Arrow for direction of rotation on router.
FIG. 11
EN
45