Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
SAFETY INSTRUCTIONS
Carefully read all the instructions, safety
instructions and warnings supplied with the
product and the router to be installed on it
before use. Failure to follow all the instructions
and safety instructions can result in the risk
of electric shock, fire and/or serious personal
injury. These instructions should be enclosed
with the product if it is sold or passed on.
Save these instructions for future reference.
•
Size of workpiece
–
Always use a feeder for workpieces
shorter than 200 mm.
–
Support workpieces longer than
1000 mm with roller supports or the
equivalent.
–
Do not attempt to work on
workpieces wider than 100 mm.
•
Only use the product to work on
workpieces with square or rectangular
cross-section. Do not attempt to work on
workpieces with circular cross-sections,
such as broomsticks or branches etc.
•
The product can be used to make shaped
edges (profiles), bevelling, joints, mortices
and dovetails. Do not use the product for
peg routing or working on end grain. Do
not attempt plunge routing, routing of
curved slots or routing with synchronised
feeding. Do not interrupt and then
resume a cut.
•
Always check that all the safety devices
are correctly fitted and in working order
before use.
•
The product is intended to be used by one
person. The user is responsible for any
accidents or risks to other persons or property.
•
Do not use the product if it is damaged,
or not working properly. Any damage
must be repaired before the product is
used again.
•
In addition to these instructions, you
should always comply with local
regulations and laws concerning health,
safety and the environment.
•
The product must only be used and
42
maintained in accordance with these
instructions and by qualified personnel.
•
Only use accessories and parts
recommended by the manufacturer.
The use of other accessories and parts
can result in a risk of personal injury.
•
Always maintain a firm footing and good
balance. Do not overreach. Avoid
unbalanced and awkward positions when
working.
•
Stay alert. Be careful at all times, and use
your common sense when working with
the product. Never use the product if you
are tired or under the influence of drugs,
alcohol or medication.
•
If the power switch does not work, it must
be replaced by an authorised service
centre or other qualified personnel.
Do not use the product if it cannot be
switched on and off with the power switch.
•
Check that the mains voltage corresponds
to the rated voltage on the type plate.
•
Always use a feeder to hold down the
workpiece and prevent kickback.
•
Router bits are very sharp – risk of cut
injuries. Handle them with care.
•
Always check before use that bits are not
cracked or otherwise damaged. Replace
cracked or damaged bits immediately.
•
Check the workpiece first, and remove any
nails, screws and other metal objects.
•
Start the product and allow it to reach
maximum speed before the bit is applied
to the workpiece.
•
Run the product without load for a few
minutes to check for abnormal noise or
vibration, which can be an indication that
the router or bit is not correctly installed.
•
Check the direction of rotation of the bit
and make sure to feed the workpiece in
the right direction.
•
Always feed the workpiece to the bit in the
opposite direction to the direction of
rotation.
•
Never leave the product unattended when
switched on.
•
Do not touch the bit just after use – it can
Werbung
Inhaltsverzeichnis
