Mains Connection - Meec tools 022532 Bedienungsanleitung

EN
Mounting on workbench
The product must be mounted on a suitable
workbench before use. There are 8 holes in the
product legs for attachment to a level surface.
The product should be positioned so that the
worktop (7) is at about elbow height.
1. Anchor the product to the surface with
suitable retaining parts.

Mains connection

The safety switch unit for the product should
be connected to an earthed power point, one-
phase 230–240 VAC, 50 Hz.
1. Check that the mains voltage corresponds
to the rated voltage on the type plate.
2. An extension cord must have a minimum
cross-sectional wire area of 1.5 mm2.
Do not use a longer than necessary extension
cord.
Fitting of table inserts
WARNING!
Never use damaged table inserts, they can
come loose and cause serious personal injury.
5 table inserts with different inner diameters
are included: 1/2", 3/4", 1", 1 1/4" and 1 1/2".
1. Select a suitable table insert for the bit to
be used and press it in place in the hole in
the worktop (7).
FIG. 25
USE
IMPORTANT:
Switch off the product and pull out the plug
before adjusting and/or maintenance.
ADJUSTING THE BIT DEPTH
1. Set the required bit depth on the router.
Follow the instructions for the router in use.
FIG. 26
48
ADJUSTMENT OF BIT WIDTH WHEN
USING PROFILE BIT
When using bits with a large diameter it
can be necessary to make several passes to
avoid overloading the router. In which case,
adjust the fence so that a smaller part of the
radius of the bit comes in contact with the
workpiece and make the necessary number of
passes before the bit width for the final pass is
adjusted as shown below.
1. Fit the required bit and adjust the bit depth
according to the instructions for the router.
2. Check that the outer edge of the ball bearing
is in line with the edge of the fence (1).
FIG. 27
3. Undo the two thumb screws (17) behind
the fence and place a ruler against the
outer edge of the ball bearing.
4. Move forward the fence so that it rests
against the edge of the ruler and tighten
the thumb screws to lock the fence in place.
FIG. 28
ADJUSTMENT OF BIT DEPTH WHEN
USING STRAIGHT BITS ( EDGE
TRIMMING )
The sliding trimmer fence is used for trimming
wooden edges with a straight bit, otherwise
the workpiece would not rest against the fence
after it had passed the rotating bit.
1. Fit the required bit on the router.
2. Undo the lock screws on the fence (1) and
move the fence to the required bit width
as shown in the figure.
FIG. 29
3. Tighten the fence screws to lock the fence
in place.
4. Undo the lock knob (B) for the trimmer
fence.
FIG. 30
5. Turn the bit by hand so that the cutting
edge is at an angle of 90° to the fence, as
shown in the figure.