Use With The Zkm Tensile Force Application Part - HBK HBM Z4A Montageanleitung

The ordering numbers for suitable thrust pieces for your Z4A can be found in section 3
"Scope of Supply and Accessories", page 7. All thrust pieces provided as Z4A acces­
sories by HBM comply with the recommendations of
7.6

Use with the ZKM tensile force application part

ZKM tensile force application parts prevent torsional moments being applied to the trans­
ducer, bending moments and misalignment are not applied either.
Installation is the same as when mounting knuckle eyes:
S
Screw the ZKM tensile force application part into the transducer or adapter as far as
the retainer
S
Screw the ZKM back two turns
The ordering numbers of ZKM tensile force application parts matching your Z4A can be
found in section 3 "Scope of Supply and Accessories", on page 7. All ZKM tensile force
application parts provided as Z4A accessories by HBM comply with the recommenda­
tions of ISO376.
20
ISO376.
MECHANICAL INSTALLATION
Z4A