What To Do If; Installation - Zanussi ZCV560M Benutzerinformation

4
4
6
5
5
Oven lamp
Warning! There is a danger of electrical shock!
Before you change the oven lamp:
• Switch off the oven.

What to do if...

Problem
The residual heat indicators does not
come on
The appliance does not operate
The oven does not heat up
The oven does not heat up
The oven lamp does not operate
Steam and condensation settle on the
food and in the oven cavity
If you cannot find a solution to the problem yourself, con-
tact your dealer or the service centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

Installation

Warning! Refer to "Safety information" chapter.
• Remove the fuses in the fuse box or switch off the cir-
cuit breaker.
Replacing the oven light bulb/cleaning the glass cover
1.
2.
3.
4.
Possible cause
The cooking zone is not hot because
it operated only for a short time
The fuse in the fuse box is released
The oven is not switched on
The necessary settings are not set
The oven lamp is defective
You left the dish in the oven for too
long
The necessary data for the service centre is on the rating
plate. The rating plate is on the front frame of the oven
cavity.
Put a cloth on the bottom of the oven for protection
of the oven light and glass cover.
Turn the glass cover anti-clockwise to remove it.
Clean the glass cover.
Replace the oven light bulb with applicable 300°C
heat-resistant oven light bulb.
Install the glass cover.
If the cooking zone must be hot,
speak to the after sales service
Control the fuse. If the fuse is re-
leased more than one time, refer to a
qualified electrician.
Switch on the oven
Control the settings
Replace the oven lamp
Do not leave the dishes in the oven
for longer than 15-20 minutes after
the cooking process ends
.........................................
.........................................
.........................................
Remedy
59