What To Do If - Zanussi ZOB382 Benutzerinformation

Shelf Support Rails
Removing the shelf support rails
1
Pull the front of the
shelf support rail away
from the side wall.
Installing the shelf support rails
Install the shelf support rails in opposite sequence.
The rounded ends of the shelf support rails must
point to the front!
Oven lamp
Warning! Be careful! There is the risk of electrical
shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or switch off the cir-
cuit breaker.
Put a cloth on the bottom of the oven for protection
of the oven light and glass cover.
1. Turn the glass cover anti-clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with applicable 300°C
heat-resistant oven light bulb.
Use the same oven lamp type.

What to do if...

Warning! Refer to "Safety information" chapter.
Problem
The appliance does not heat up.
24
2
1
2
Pull the rear shelf sup-
port rail away from the
side wall and remove it.
Possible cause
The appliance is deactivated.
4. Install the glass cover.
Cleaning the oven door
You can remove the oven door to clean it.
1
Open the door fully
and hold the two door
hinges.
3
Close the oven door to
the first opening position
(halfway). Then pull for-
ward and remove the door
from its seat. Put the door
on a soft cloth on a stable
surface.
Clean the oven door with water and soap. Dry the oven
door carefully.
When the cleaning is completed, install the oven door. To
install the oven door, do the above steps in the opposite
sequence.
Activate the appliance. Refer to "Daily
use".
2
Lift and turn the levers
on the two hinges.
Remedy