What To Do If - Zanussi ZOB361 Benutzerinformation

1
Open the door fully
and hold the two door
hinges.
3
Close the oven door to
the first opening position
(halfway). Then pull for-
ward and remove it from
its seat. Place the door on
a stable surface protected
by a soft cloth.
Clean the glass panel with water and soap. Dry it carefully.

What to do if...

Problem
The oven does not heat up
The oven does not heat up
The oven lamp does not operate
Steam and condensation settle on the
food and in the oven cavity
If you can not find a solution to the problem, speak to your
dealer or the Service Force Centre.
18
2
Lift and turn the levers
on the two hinges.
Possible cause
The oven is not switched on
The fuse in the fuse box is released
The oven lamp is defective
You left the dish in the oven for too
long
When the cleaning procedure is completed, insert the
oven door. To do so, do the steps in reverse.
Stainless steel or aluminium appliances:
Clean the oven door with a wet sponge only. Dry it
with a soft cloth.
Do not use steel wool, acids or abrasive materials as they
can damage the oven surface. Clean the oven control
panel with the same precautions.
Oven lamp
Warning! There is a danger of electrical shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or switch off the cir-
cuit breaker.
Put a cloth on the bottom of the oven for protection
of the oven light and glass cover.
Replacing the oven light bulb/cleaning the glass
cover
1. Turn the glass cover anti-clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with applicable 300°C
heat-resistant oven light bulb.
4. Install the glass cover.
Switch on the oven (refer to chapter
"Daily use").
Control the fuse. If the fuse is re-
leased more than one time, refer to a
qualified electrician.
Replace the oven lamp
Do not leave the dishes in the oven
for longer than 15-20 minutes after
the cooking process ends
These data are necessary to help you quickly and
correctly. These data are available on the rating plate (refer
to "Product description")
• Model description ............
Remedy