Introduction; Device Description (Fig. 1-16); Scope Of Delivery - Parkside PDS 120 B2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

2. Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws, the
manufacturer of this device assumes no liability for damage to
the device or caused by the device arising from:
• Improper handling,
• Non-compliance with the operating manual,
• Repairs carried out by third parties, unauthorised specialists,
• Installing and replacing non-original spare parts,
• Application other than specified,
• Failure of the electrical system in the event of the electrical
regulations and VDE provisions 0100, DIN 13/VDE0113
not being observed.
Please consider:
Read through the complete text in the operating manual before
installing and commissioning the device.
This operating manual should help you to familiarise yourself
with your device and to use it for its intended purpose.
The operating manual includes important instructions for safe,
proper and economic operation of the device, for avoiding
danger, for minimising repair costs and downtimes, and for
increasing the reliability and extending the service life of the
device.
In addition to the safety instructions in this operating manual,
you must also observe the regulations applicable to the
operation of the device in your country.
Keep the operating manual at the device, in a plastic sleeve,
protected from dirt and moisture. They must be read and
carefully observed by all operating personnel before starting
the work.
The device may only be used by personnel who have been
trained to use it and who have been instructed with respect to
the associated hazards. The required minimum age must be
observed.
In addition to the safety instructions in this operating manual
and the separate regulations of your country, the generally
recognised technical rules relating to the operation of such
machines must also be observed.
We accept no liability for accidents or damage that occur due
to a failure to observe this manual and the safety instructions.

3. Device description (fig. 1-16)

1. Blow-off device
2. Holder (blow-off device)
3. Knurled screw
4. Holder (saw blade guard)
5. Saw blade guard
6. Saw table
7. Foot pedal
8. Cover, left
9. Storage box
10. Bearings
11. Tightening lever
12. Arm
13. Graduated scale
14. Knurled nut
15. Extraction connection
16. On/off switch
17. Operating mode selection switch
18. Stroke rate controller
19. Assembly points (premounted rubber feet)
20. Work lamp
21. On/off switch work lamp
22. Saw blade
23. Allen key 3 mm
24. Depressor
25. Screw (depressor)
26. Table inlay
27. Top saw blade holder
28. Upper saw blade clamping screw
29. Lower saw blade clamping screw
30. Bottom saw blade holder
31. Angle
32. Screw (graduated scale)
33. Pointer
34. Screw (left cover - front)
35. Screw (left cover - rear)
36. Fine-wire fuse
37. Adjustment screw with locknut

4. Scope of delivery

• Scroll saw
• Saw blade guard (5) with depressor (24)
• Blow-off device (1)
• Saw blade (22) for wood and plastics (4x) (1x premounted)
• Angle
• Drill template
• bolt bag: 4 hexagon screws M8 x 50, 4 hexagon nuts M8,
8 washers
• Allen key 3 mm (23)
• Translation of the original operating manual
GB/MT 29