Changing Air-Oil Separator; Cleaning Radiator - Comprag DV9010 Bedienungsanleitung

5.5

Changing air-oil separator

Fig. 5.5 Changing air-oil separator
5.6

Cleaning radiator

Fig 5.6. Cleaning radiator
+7 (800) 777-83-75(звонок бесплатный)
www.v-p-k.ru
The separating component is located
within the separator tank. Open the front
panel in order to change it. Unscrew the
bolts (2) and carefully remove the top
cap of the tank. Disconnect hoses if they
make it difficult to remove the cap.
Remove the spent separator and install
a new one in its place. Refasten the tank
cap.
Open the left side panel.
Regularly clean the radiator in order to
maintain its cooling efficiency at an
acceptable level.
Remove any dirt particles from the
radiator using a fibre brush, then aim
a jet of compressed air at the radiator
from the bottom to the top; the jet should
be held at an approximate 90° angle to
the plane of the radiator.
DV9010