Bluetooth Audio Function; Troubleshooting; Cleaning And Maintenance - SPORTSTECH sWalk Benutzerhandbuch

5. Bluetooth audio function

You can use the loudspeakers on the console to play audio from your terminal.
• Switch on the Bluetooth function on the playback device. Make the playback device visible in Bluetooth.
• Select 'BTMP3' from the list of nearby Bluetooth devices and pair with your playback device.
• Control playback and volume via your playback device.

6. Troubleshooting

Problem
Device does not switch
on or does not start
Running belt slips
Running belt faltering
during use
Running belt not
centred
In all cases of doubt, contact our customer service. You find the contact details on the last page.

7. Cleaning and maintenance

7.1 CLEANING
• After each use, wipe sweat from the device with a slightly wetted cloth.
• Never allow moisture or humidity to reach the computer or other electrical or electronic components.
• Do not use abrasives or solvents.
7.2 MAINTENANCE
• Before and after each training session, check that the device is in perfect condition. Also check that
all fastening parts and protective covers are in place and intact. Tighten bolts and nuts if necessary.
7.3 LUBRICATING
For proper functioning and long life of the device, the running belt must be adequately lubricated with
silicone oil. There are thin tubes on the underside of the device as a lubrication system.
7.3.1 Lubrication and inspection intervals
• Refill with silicone oil after the first 25 hours of operation (or 2-3 months).
• Check the lubrication regularly.
• Top up with silicone oil at least every 50 operating hours (or 5-8 months).
• Run on the treadmill at a slow speed for 3 to 5 minutes to evenly distribute lubricant.
7.3.2 Checking lubrication
• Make sure that the electrical supply plug of the device is disconnected.
• Lift the running belt on one side. Run your finger over the top of the running deck under the running
belt.
- If the running deck feels slightly oily, the lubrication is sufficient
- However, if the running deck feels dry, you need to top up with silicone oil.
Possible reason
Power cable not plugged in
Electronic fuse has tripped
Running belt not tightened enough
Running belt not lubricated enough
Running belt too tight
Running belt unevenly tensioned
Possible solution
Plug in the power cable
Press the reset button next to the
power connection on the device.
Tension the running belt
Refill silicone oil
Relax the running belt
Adjust the running belt centrally
DE
EN
29