EKOM DK50 2V/M Benutzerhandbuch Seite 27

INSTALLATION

Remove transport fixing elements from the pumps (Fig. 5).
Prior to installation, ensure that the compressor is free of all transport packaging
and stabilizers to avoid any risk of damage to the product.
Remove fixing elements of the pumps once the compressor has been assembled
and balanced at the final installation place.
Fig. 5: Releasing the pump
11.2. Changing door direction

Disconnect the earthing conductor from the cabinet. (A)

Remove the door, the rectifying screws on both sides of the cabinet (3) and the hinge (4)
bracket (2). (B)

Install the bracket for hinge (2) on the left side of the cabinet. (C)

Rotate the door 180º. (B)

Insert the spacer (5) between hinge (1) and the bottom of the door. (C)

Install the door, the 2 rectification screws (3) and connect the earthing conductor. (C)

Remove the door lock (6) and rotate 180º. (D)

Remove the latch (7) and rotate 180º. (D)

Install the lock. (D)
A
10/2022 27 NP-DK50 2V-3_10-2022-AD