EKOM DK50 2V/M Benutzerhandbuch Seite 12

Risk of compressor overheating.
Make sure that there are no obstacles at the cooling air inlet into the cabinet
(around the bottom part of the cabinet) and at the hot air outlet on the top back
side of the cabinet.
If the compressor is placed on a soft floor, e.g. carpet, create space between the
base and the floor or the cabinet and the floor, e.g. underlay the footings with
hard pads to ensure sufficient cooling of the compressor.
Description to Figures 1 - 3
1 Air pump
2 Air tank
3 Non-return valve
4 Pressure switch
5 Safety valve
6 Pressure gauge
7 Inlet filter
8 Adsorption dryer
9 Compressor fan
10 Condensate collection vessel
11 Magnetic holder
12 Electric panel
13 Cabinet fan
14 Door pin
15 Rectifying screw
16 Lock
17 Supporting bracket
18 Wall stop
19 Switch
* Position 34 applies to the DK50 2V/M model without the cabinet; position 34 in the case of
the DK50 2VS/M with the cabinet is a simple cover.
** For the cabinet model, the cable connected to the display (36) in the front panel of the cabinet
is routed through the universal bushing.
NP-DK50 2V-3_10-2022-AD
20 Cabinet pressure gauge
21 Door hinge
22 Handle
23 Casters
24 Pressure gauge hose
25 Outlet module
26 Cooling module
27 Dryer chamber
28 Inlet valve module
29 Compressed air inlet
30 Regeneration solenoid valve
31 Dryer fan
32 Condensate separtor
33 Condensate drain solenoid valve
34 *Display
35 Air outlet
36 **Bushing
37 Outlet from condensate separator and
regeneration valves
12
PRODUCT DESCRIPTION
10/2022