Service; Safety Instructions For Drills; Original Accessories/Attachments - Parkside Performance PSBSAP 20-Li B2 Originalbetriebsanleitung

d) Fluids may leak out of rechargeable battery
units if they are misused. If this happens, avoid
contact with the fluid. If contact occurs, flush
the affected area with water. Seek additional
medical help if any of the fluid gets into your
eyes. Escaping battery fluid may cause skin
irritation or burns.
e) Do not use a damaged or modified battery.
Damaged or modified batteries may behave
unexpectedly and cause fires, explosions or
pose a risk of injury.
f) Do not expose a battery to fire or excessively
high temperatures. Fire or temperatures in
excess of 130°C (265°F) can cause an
explosion.
g) Follow all instructions regarding charging
and never charge the battery or the cordless
tool outside of the temperature range given in
the operating instructions. Incorrect charging
or charging outside of the permissible tempera-
ture range can destroy the battery and increase
the risk of fire.
CAUTION! RISK OF EXPLOSION!
Never charge non-rechargeable
batteries.
battery from heat (for example, from
continuous exposure to sunlight), fire, water
and moisture. There is a risk of explosion.

6. Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
b) Never try to repair damaged batteries.
Maintenance of batteries should only be car-
ried out by the manufacturer or an approved
customer service centre.
6
GB │ CY
│
■
Protect the rechargeable

Safety instructions for drills

Safety instructions for all work
■ Wear ear muffs when hammer drilling.
Exposure to loud noise can lead to hearing loss.
■ Use the additional handle(s). Loss of control
can lead to injuries.
■ Hold the tool by the insulated gripping surfac-
es when performing work where the screws
or the accessory tool may hit hidden power
lines. If the accessory tool or the screws come
into contact with a live wire, this may make
exposed metal parts of the power tool live and
result in an electric shock.
■ Collect any dust that is produced; for example,
using a vacuum cleaner.
Safety information for using long drill bits
■ Do not use a higher rotational speed than
the maximum permissible speed. At higher
speeds, the drill bit can bend slightly if allowed
to turn freely without being in contact with the
workpiece and this can lead to injuries.
■ Always start drilling at a low speed and with
the drill bit in contact with the workpiece. At
higher speeds, the drill bit can bend slightly if
allowed to turn freely without being in contact
with the workpiece and this can lead to injuries.
■ Do not exert excessive pressure and only
apply pressure along the length of the drill bit
(no lateral pressure). Drill bits can bend and
break which can lead to a loss of control and
injuries.

Original accessories/attachments

■ Use only the accessories and attachments
which are specified in the operating instructions
and are compatible with the tool.
WARNING!
■ Do not use any accessories that are not
recommended by PARKSIDE. This can lead to
electric shock and fire.
PSBSAP 20-Li B2