Inhaltsverzeichnis
Werbung
30
PRODUCT INFORMATION
1
4
Fig. A.
1. On/off switch
2. Dust exhauster adaptor
3. Paper clamp
4. Sand sole
Ferm
Ferm
OPERATION
Choice of the sand-paper.
Coarse sand-paper (grain 50) removes in general the big-
ger part of the material and fine sand-paper is used for the
finishing. If the surface is not even, then start with rough
sand-paper. Further you use middlecoarse sand-paper
(grain 80) to remove the scratches left behind by the coar-
se sand-paper and finally you take fine sand-paper (grain
120) for the finishing.
2
Installing sand-paper.
The sanding machine is provided with a rectangle sand
sole. By tightening the sand-paper it does not wear out that
3
fast and so it will wear well longer.
•
Pull the mains plug out of the power-point;
•
Open the hindmost clamp by pressing up the inter-
locking;
•
Install the sand-paper under the clamp, see to the pa-
per being in the middle and look after the perforations
in the paper. They have to correspond with those on
the sand sole, so that the dust can be exhausted.
•
Put the clamping spring back into the original position.
•
Repeat the operation to fix the sand-paper on the front
side.
•
Check all the time if the exhaust gaps are not stopped
up when you place the sand-paper, and check if the
perforations in the sand-paper correspond with the ex-
haust gaps.
•
Fix the sand-paper as tight as possible.
Before assembly sanding paper always remove
the plug from the mains.
3
Werbung
Inhaltsverzeichnis
