Assembly - Parkside PWD 20 A1 Originalbetriebsanleitung

GB IE NI
socket with a fuse of at least
16 A.
• Connect the appliance to a
socket with a residual current
device (RCD) with a tripping
current of not more than 30 mA.
• Ensure that the power line does
not become damage by being
pulled over sharp edges, be-
coming trapped or by pulling
on the line.
• Never use the power line to pull
the plug out of the socket or to
pull the appliance. Protect the
power line from heat, oil and
sharp edges.
• Switch the appliance off and
unplug the power chord:
- when you are not using the
device or when you are
transporting or leaving it un-
attended;
- when you inspect the ma-
chine, clean it or remove
blockages;
- when you perform cleaning
or maintenance work, or
swap accessories;
- if the connection cable is
damaged or entangled,
- after contact with foreign
bodies or if abnormal vibra-
tion occurs.
• If the mains connection cable
of this appliance is damaged,
it must be replaced by the
manufacturer or their customer
service or by a similarly quali-
fi ed person in order to avoid
hazards.
8
CY
This is how to avoid damage
to the appliance and possi-
ble personal injuries result-
ing from this:
• Make sure before use that the
appliance is properly assem-
bled and that the fi lters are in
the correct position.
• Do not perform vacuuming
without fi lters. The device could
become damaged.
• Only use original spare parts
and accessories (see "Spare
Parts/Accessories"), which are
supplied and recommended by
our service centre. Using exter-
nally produced parts results in
the immediate loss of the war-
ranty claim.
• Only have repairs performed by
customer service centres author-
ised by us.
• Comply with the appliance's
cleaning and maintenance in-
structions.
• Store the device in a dry place
and out of reach of children.

Assembly

NOTE! The appliance is delivered with a
motor head (1) attached. To remove the
motor head, open the fastening clips (8).
1. Remove the mains plug.
2. Place the feet (7) into the receptors on
the dirt container (6).
3. Insert the desired fi lter if it is not pre-
mounted:
- Foam fi lter for wet suction (
- Textile fi lter bag (
suction,
- Paper fi lter bag (
15),
16) for dry
17).