React AERO Montageanleitung Seite 29

Step 10
Connect each upper safety pole and lower safety pole together by the pin and make sure the pin locked.
Cover the en�re pole with sleeves. Insert the curved enclosure poles into the two welded tubes of the leg
tube one by one,�ghten by screws
Step 11
Stand on the jumping mat and then pick up the safety net and insert
them to the black top hats one by one.
A�en�on: Keep the entrance of safety net in the middle of two
connector and the same direc�on with the bounce mat logo.
and nuts, as shown in the picture.
- 12 -
Step 12
Tie black tape through the
bo�om hole of safety net and
triangle ring one by one, starts
from the entrance of safety net.