Frame Assembly - React AERO Montageanleitung

Set-up the trampoline in its final loca�on! A�er complete set-up, DO NOT MOVE the trampoline
a�er assembly! Make sure the ground is level at the set up loca�on otherwise the tension of
the springs might deform the frame.
We Recommend: That the Trampoline MUST be set up on grassed area only. Not suitable on
concrete or other hard surfaces.
WARNING: 2-3 adults in good physical condi�on are required for the following assembly. You
MUST wear closed in shoes and gloves. Make sure area around assembly area is clear of any
hazards which may cause a fall or loss of balance. Failure to follow all instruc�ons and warnings
exactly may result in serious injury.
Lay out all trampoline and safety net parts in groups. Check, prior to assembly, that all parts
are complete according to the parts list.
Step 1
Put all frame tubes and T-tube
connectors in a circle as shown.

FRAME ASSEMBLY

WARNING!
Step 2
The two ends of frame tube are
different. One end is smaller,
the other is bigger. To make it
easy to assemble, first insert
the frame tube's bigger end
into the T connector, then
insert the small end of another
frame tube into the same T
connector. Repeat un�l all the
frame tubes and connectors
are connected.
Note: The welded tube of T
tube connector must face
outside.
- 10 -
Step 3
Connect the leg extensions
tube with the "W" shape leg
tubes as shown in the picture.
Make sure the pin locked.